Ieee 1394 Cable Specifications; Figure 2-8. 24V Connectors - adept technology Adept RS-232/TERM User Manual

24VDC connector
Adept Part # 25040-00201
NOTE: Although no damage will occur, the SmartController will not turn
on if the DC polarities on the XDC connectors are reversed.

IEEE 1394 Cable Specifications

Adept supplies the IEEE 1394 cables to connect the SmartController to other Adept
devices in the system. If you need a cable of a different length than those supplied by
Adept, then you must purchase a cable from one of the Adept-approved vendors listed
below:
• Newnex Technology Corp. Go to
• Molex, Inc. Go to
These purchased cables must meet all specifications of the IEEE 1394 standard. Note that
Adept uses 6-pin to 6-pin cables. The maximum length for a 1394 cable is 4.5 meters. The
1394 Trade Association provides detailed specifications for 1394 cables and other related
information, see
www.1394ta.org.
WARNING:
by Adept that meet all specifications of the IEEE 1394
standard. Using a non-approved or inferior quality IEEE
1394 cable can cause unpredictable system performance.
Adept SmartController User's Guide, Rev. E
negative (-)
positive (+)

Figure 2-8. 24V Connectors

www.newnex.com
www.molex.com
You must use cables from vendors approved
Controller Installation
Insert small flat-blade screwdriver
to open clamp.
Insert wire, then remove screwdriver
to secure wire in clamp.
33