Rs-422/485 Connector; Table 3-5. Serial Connectors And; Table 3-6. Rs-422/485 Connector Pin Assignments - adept technology Adept RS-232/TERM User Manual

NOTE: To configure the port speed and other communications
parameters, use the CONFIG_C utility program, the V
instruction, or the FSET monitor command.
Table 3-5. Serial Connectors and V
Controller
CS and CX
CS and CX
CX only
CX only

RS-422/485 Connector

The RS-422/485 connector is a 9-pin DB9 male connector. The pin assignments are shown
in Table 3-6. RS-422 is a point-to-point protocol for connecting to a single destination. This
port can also be configured as a multidrop port (RS-485).
To change the configuration of the RS-422/485 port, use the CONFIG_C utility program or
+
the V FSET program instruction. See
+
a V ATTACH or FSET instruction.

Table 3-6. RS-422/485 Connector Pin Assignments

Adept SmartController User's Guide, Rev. E
Connector
RS-422/485
RS-232/Term
RS-232-1
RS-232-2
Table 3-5
Pin Signal
1 NC
2 RXD+
3 TXD+
4 TXD-
5 GND
6 RXD–
7 NC
8 NC
9 NC
SmartController Serial I/O Connectors
+
FSET program
+
Designations
+
V Designation
LOCAL.SERIAL:1
LOCAL.SERIAL:2
SERIAL:1
SERIAL:2
+
for the V designation when referenced in
Type
Input
Output
Output
Ground
Input
45