30/DISASSEMBLING THE ENGINE
Removing primary gear
17.24
Removing starter drive
17.25
Removing shift shaft
17.26
Removing shift drum locating
17.27
–
Plug the special tool into the crankshaft.
Protection cover (75029090000) (
–
Screw the special tool
Extractor (75029021000) (
–
Hold it using the special tool and pull off the primary gear by turning the screw in.
–
Remove the special tools.
300062-10
–
Remove the lock ring of the starter idler gear
–
Take off the starter idler gear
–
Remove the torque limiter
300064-10
–
Take off the free-wheel gear
–
Remove the woodruff key
300065-10
–
Push sliding plate
with the washer.
300066-10
–
Remove screw
–
Press locking lever
locating.
–
Release the locking lever.
300067-10
p. 215)
on to the primary gear
p. 212)
with the washers.
with the washers and needle bearing.
.
and both needle bearings
away from the shift drum locating
.
away from shift drum locating
.
and the torque limiter
.
.
. Remove shift shaft
and take off the shift drum
102