Removing Primary Gear; Removing Starter Drive; Removing Shift Shaft; Removing Shift Drum Locating - KTM 2011 690 SMC EU Repair Manual

16 ENGINE

16.3.24 Removing primary gear

16.3.25 Removing starter drive

16.3.26 Removing shift shaft

16.3.27 Removing shift drum locating

–
Plug the special tool into the crankshaft.
Protection cover (75029090000) (
–
Screw the special tool
Extractor (75029021000) (
–
Hold it using the special tool and pull off the primary gear by turning the screw in.
–
Remove the special tools.
300062-10
–
Remove the lock ring of the starter idler gear
–
Take off the starter idler gear
–
Remove the torque limiter
300064-10
–
Take off the free-wheel gear
–
Remove the woodruff key
300065-10
–
Push sliding plate
with the washer.
300066-10
–
Remove screw
–
Press locking lever
locating.
–
Release the locking lever.
300067-10
p. 217)
on to the primary gear
1
p. 214)
with the washers.
1
with the washers and needle bearing.
2
.
3
and both needle bearings
4
away from the shift drum locating
1
.
1
away from shift drum locating
2
.
2
and the torque limiter
1 2
.
5
. Remove shift shaft
2
and take off the shift drum
3
114
.
3