13/BRAKE SYSTEM
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
Changing the rear brake fluid
14.13
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
–
Stand the vehicle upright.
–
Remove screw cap
–
Add brake fluid to the MAX mark.
Brake fluid DOT 4 / DOT 5.1 (
–
Mount the screw cap with the washer and membrane.
Info
Clean up overflowed or spilt brake fluid immediately with water.
100259-10
–
Remove screw cap
–
Draw the old brake fluid out of the brake fluid reservoir using a syringe and fill with
fresh brake fluid.
Bleed syringe (50329050000) (
Brake fluid DOT 4 / DOT 5.1 (
301893-10
–
Pull off dust cap
workshop equipment).
–
Release bleeder screw
Info
During suction, ensure that the brake fluid reservoir is always filled with a
sufficient amount of fresh brake fluid.
–
Tighten the bleeder screw. Remove the suction device and mount the dust cap.
302043-10
with the washer and membrane
p. 204)
with washer
and membrane
p. 208)
p. 204)
and connect a commercially available suction device (standard
and draw out the old brake fluid.
80
.
.