04/SHOCK ABSORBER, SWINGARM
Checking the damper
7.15
–
Remove supporting plate
Info
Thread the rebound shim set on a screwdriver and set the parts down
together.
300541-10
–
Remove compression shim stack
Info
Thread the compression shim stack on a screwdriver and set the parts down
together.
200572-11
–
Remove seal ring retainer
300542-10
–
Remove locking cap
300543-10
Condition
The damper has been disassembled.
–
Measure the inside diameter at both ends and in the center of the damper car-
tridge.
Damper cartridge
Minimum diameter
»
If the measured value is greater than the specified value:
–
Change the damper cartridge.
–
Check the damper cartridge for damage and wear.
»
If there is damage or wear:
300596-10
–
Change the damper cartridge.
and rebound shim stack
with supporting plate
.
and rubber buffer
.
46.10 mm (1.815 in)
37
together with piston
.
.