41/THROTTLE VALVE BODY
Loctite
–
Press "Continue".
–
Open and close the throttle grip fully ten times.
The "Continue" button appears.
–
Press "Continue".
–
Check the voltage value.
Info
The "Continue" button only appears if the measured value equals the set-
point value.
Throttle position sensor circuit A
Emergency running position - volt-
age "THAD"
»
If the displayed value is not equal to the setpoint value:
–
Repeat the setting.
–
Fix fuse cover
601135-10
–
Use "Continue" to start the "Adjusting the position of the throttle grip sensor" menu.
–
Check the voltage value.
Info
The "Continue" button only appears if the measured value equals the set-
point value.
Throttle grip sensor
Voltage "APAD"
»
If the displayed value is not equal to the setpoint value:
–
Loosen screws
–
Adjust the accelerator position sensor
–
Tighten screws
–
Press "Continue".
–
Open and close the throttle grip fully ten times.
The "Continue" button appears.
–
Press "Continue".
–
Check the voltage value.
600946-11
Info
The "Continue" button only appears if the measured value equals the set-
point value.
Throttle grip sensor
Voltage "APAD"
»
If the displayed value is not equal to the setpoint value:
–
Repeat the setting.
®
648™
Info
Tighten by hand only, do not use a tool.
0.70... 0.74 V
with locking varnish.
0.70... 0.74 V
.
.
0.70... 0.74 V
by turning to the specified value.
163