04/SHOCK ABSORBER, SWINGARM
Removing the heim joint
7.16
–
Measure the diameter of the piston rod.
Piston rod
Diameter
»
If the specification is not reached:
–
Change the piston rod.
–
Measure the run-out of the piston rod.
Piston rod
300554-10
Run-out
»
If the measured value is greater than the specified value:
–
Change the piston rod.
–
Check the piston rod for damage and wear.
»
If there is damage or wear:
–
Change the piston rod.
–
Check the heim joint for damage and wear.
»
If there is damage or wear:
–
Change the heim joint.
300460-01
Condition
The shock absorber has been removed.
–
Clamp the shock absorber in the vise using soft jaws for protection.
–
Remove collar bushing
Pin (T120) (
–
Turn over the shock absorber and remove collar bushing
Pin (T120) (
200577-10
–
Remove seal rings
200578-10
≥ 17.95 mm (≥ 0.7067 in)
≤ 0.03 mm (≤ 0.0012 in)
of the heim joint.
p. 217)
p. 217)
on both sides.
38
of the heim joint.