30/DISASSEMBLING THE ENGINE
Removing the clutch bearing
15.24
Removing the primary gear
15.25
Removing the left engine case
15.26
–
Remove needle bearings
300486-11
–
Remove nut
–
Take off primary gear
–
Remove the spring washer and washer.
300494-10
–
Remove screws
–
Swing the left section of the engine case up and remove the screw connection of
the engine holder.
300498-10
–
Mount the special tool on the crankshaft.
Protecting sleeve (45229090000) (
–
Mount the special tool.
Extractor (45229048000) (
Info
Use the hole labeled 452.
300987-10
–
Separate the engine case sections by screwing in screw
Info
Ensure that the engine case section is raised evenly.
–
Take off the left section of the engine case.
–
Remove the special tools.
–
Remove the spacer of the countershaft with the O-ring.
Info
The spacer of the countershaft usually remains in the engine case.
and collar bushing
.
.
.
p. 148)
p. 147)
.
.
74