01/FORK, TRIPLE CLAMP
Installing the fork legs
5.8
–
Loosen the screws
201379-10
–
Slide the fork legs into the triple clamps on both sides.
Info
The bleeder screws must face forwards.
The topmost milled groove in the fork leg must be flush with the top edge of
the upper triple clamp.
The upper fork projection must be the same on both sides.
–
Tighten screws
Guideline
201379-11
Screw, top triple clamp
Screw, bottom triple clamp
–
Position the fork protection. Mount and tighten screws
Guideline
Remaining screws, chassis
201378-11
–
Position the wheel speed sensor. Mount and tighten screws
Guideline
Screw, wheel speed sensor M4
201377-11
–
Position the brake line, wiring harness and clamp.
–
Mount and tighten screws
201376-11
of the triple clamp. Remove the fork legs from the bottom.
on both sides.
M8
M8
M6
.
17 Nm
(12.5 lbf ft)
12 Nm (8.9 lbf ft)
.
10 Nm (7.4 lbf ft)
.
2 Nm
Loctite
®
243™
(1.5 lbf ft)
15