Table of Contents
Advertisement
38/LUBRICATION SYSTEM
Removing the oil filter
22.6
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Installing the oil filter
22.7
–
Thoroughly clean the oil drain plug with a magnet.
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Refit the oil drain plug with the magnet and seal ring and tighten it.
Guideline
Oil drain plug with magnet
100201-01
–
Place a suitable container under the engine.
–
Remove screws
–
Pull oil filter
Circlip pliers reverse (51012011000) (
100202-10
–
Remove screws
–
Pull oil filter
Circlip pliers reverse (51012011000) (
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
100203-10
–
Insert oil filters
–
Oil the O-rings of the oil filter covers. Mount oil filter covers
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
100204-10
. Remove the oil filter cover
out of the oil filter housing.
. Remove oil filter
with the O-ring.
out of the oil filter housing.
and
.
M12x1.5
20 Nm
(14.8 lbf ft)
with the O-ring.
p. 208)
p. 208)
and
.
M5
6 Nm (4.4 lbf ft)
155
Advertisement
Table of Contents
