Table of Contents
Advertisement
41/THROTTLE VALVE BODY
–
Carefully close the throttle valve with your finger and hold it.
–
Check the voltage value.
Info
The "Continue" button only appears if the measured value equals the set-
point value.
Throttle position sensor circuit A
Basic position - voltage "THAD"
»
If the displayed value is not equal to the setpoint value:
–
Loosen screw
–
Adjust the throttle position sensor circuit A
value.
–
Tighten screws
–
Press "Continue".
–
Release the throttle valve.
–
Open and close the throttle grip fully ten times.
The "Continue" button appears.
601133-10
–
Press "Continue".
–
Carefully close the throttle valve again with your finger and hold it.
–
Check the voltage value.
Info
The "Continue" button only appears if the measured value equals the set-
point value.
Throttle position sensor circuit A
Basic position - voltage "THAD"
»
If the displayed value is not equal to the setpoint value:
–
Repeat the setting.
–
Use "Continue" to start the "Adjusting the emergency position of the throttle valve"
menu.
–
Release the throttle valve.
–
Fix screws
601133-11
–
Check the voltage value.
Info
The "Continue" button only appears if the measured value equals the set-
point value.
Throttle position sensor circuit A
Emergency running position - volt-
age "THAD"
»
If the displayed value is not equal to the setpoint value:
–
Screw off fuse cover
–
Loosen nut
–
Adjust the emergency running position by turning screw
value.
–
Tighten nut
–
Mount and tighten fuse cover
601134-10
.
.
with locking varnish.
.
.
.
.
0.50... 0.54 V
by turning to the specified
0.50... 0.54 V
0.70... 0.74 V
to the specified
162
Advertisement
Table of Contents
