14/LIGHT SYSTEM, INSTRUMENTS
Setting kilometers or miles
15.1
Info
If you change the unit, the value ODO is retained and converted accordingly.
Making the setting according to the country.
Setting the clock
15.2
Combination instrument - setting/resetting TRIP 1
15.3
Info
The TRIP 1 trip counter is always running and counts up to 999.9.
The trip counter can be used to measure the distance covered during trips or between two refueling stops. After the value
999.9 is reached, the trip counter starts at 0.0 again.
Condition
The motorcycle is stationary.
–
Switch on the ignition by turning the ignition key in the position
690 SMC AUS/UK)
–
Press the MODE button repeatedly until the ODO mode is active.
–
Keep the MODE button pressed until the display mode changes from km/h to mph or
from mph to km/h.
700120-01
Condition
The motorcycle is stationary.
–
Switch on the ignition by turning the ignition key in the position
690 SMC AUS/UK)
–
Press the MODE button repeatedly until the ODO mode is active.
–
Keep the MODE button and the SET button pressed simultaneously.
The time display begins to flash.
–
Press the MODE button to set the hour.
–
Press the SET button to set the minute.
–
Keep the MODE button and the SET button pressed simultaneously.
700115-10
The time is set.
–
Switch on the ignition by turning the ignition key in the position
690 SMC AUS/UK)
–
Press the MODE button repeatedly until the TRIP 1 mode is active.
–
Keep the SET button pressed.
The TRIP 1 display is set to 0.0.
700121-01
(690 SMC USA).
(690 SMC USA).
(690 SMC USA).
82
(690 SMC EU,
(690 SMC EU,
(690 SMC EU,