30/ASSEMBLING THE ENGINE
Installing spark plug
19.23
Installing spacer and spring
19.24
Installing clutch cover
19.25
–
Remove shims
–
Correct the shims as indicated by the results of the valve clearance check.
–
Insert suitable shims.
–
Position the rocker arms and push in the rocker arm shafts.
Info
Make sure that the tapped hole of the rocker arm shaft is positioned facing
outwards.
The small drill hole and the flat surface must point upwards.
300158-10
–
Install and tighten the screws
Guideline
Screw, rocker arm shaft
–
Check the valve clearance. (
300156-11
–
Mount and tighten the spark plug
Guideline
Spark plug
Spark plug wrench (75029172000) (
300016-11
–
Install the spacer
300154-10
–
Mount the dowels. Put on the clutch cover seal.
–
Position the clutch cover. Mount and tighten screws
Guideline
Screw, clutch cover
300015-11
and set them down according to the installation position.
of the rocker arm shafts.
M6
p. 142)
using the special tool.
M12x1.25
p. 216)
and spring
of the shift shaft.
M6
143
12 Nm (8.9 lbf ft)
17 Nm
(12.5 lbf ft)
.
10 Nm (7.4 lbf ft)