30/ENGINE - WORK ON INDIVIDUAL PARTS
Installing rocker arm
18.28
Dismantling antihopping clutch
18.29
–
Position the rocker arm
Info
Make sure that the tapped hole of the rocker arm shaft is positioned facing
outwards.
The small drill hole and the flat surface must point upwards.
300114-11
–
Install and tighten the screws
Guideline
Screw, rocker arm shaft
300113-11
–
Clamp the clutch
Info
Use soft jaws.
–
Carefully loosen and gradually remove the special tool
300120-10
–
Take the clutch out of the vise and lay it on a clean workbench with the outer
clutch hub
–
Take the inner clutch hub
300121-10
–
Take off the clutch disks
–
Remove pretension ring
–
Clean all parts well.
–
Check the clutch. (
300122-10
and push in the rocker arm shafts
of the rocker arm shafts.
in a vise.
facing down.
and release springs
from the inner clutch hub.
and support ring
p. 122)
.
M6
12 Nm (8.9 lbf ft)
.
out of the outer clutch hub
.
121
.