30/ENGINE - WORK ON INDIVIDUAL PARTS
Removing valves
18.22
–
Remove the small camshaft bearing
Insert for bearing puller (15112018100) (
Bearing puller (15112017000) (
300228-10
–
Press in the small camshaft bearing as far as possible using the special tool
Push-in drift (75029044020) (
300229-10
–
Press in the large camshaft bearing as far as possible using the special tool
Push-in drift (75029044010) (
–
Install the rocker arm. (
300230-10
–
Take the shims
ing to their normal built-in position.
300115-10
–
Pretension the valve springs using the special tool.
Valve spring compressor (59029019000) (
Valve spring mounting device (78029060000) (
–
Remove valve keys and release tension on the valve springs.
–
Remove spring retainers and spring.
–
Pull the valve down and out of the valve guide, remove the valve stem seal and
valve spring retainer.
300116-10
–
Mark the valves according to their normal built-in position.
Info
Place the valve into a box according to the installation position and label the
box.
300117-10
using the special tool.
p. 208)
p. 213)
p. 213)
p. 121)
out of the valve spring retainers and lay them to one side accord-
p. 208)
p. 209)
p. 216)
118
.
.