Table of Contents
Advertisement
10/REAR WHEEL
Adjusting chain guide
12.5
Checking the chain, rear sprocket and engine sprocket
12.6
–
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning adjusting screws
Guideline
Chain tension
Turn the left and right adjusting screws
and right chain adjusters
marks
. The rear wheel is then correctly aligned.
Info
The upper chain section must be taut.
Chain wear is not always even, so you should check this setting at different
chain positions.
–
Tighten nuts
–
Make sure that the chain adjusters
–
Tighten nut
Guideline
Nut, rear wheel spindle
600597-10
Info
The wide adjustment range of the chain adjusters (30 mm (1.18 in))
enables different secondary transmissions with the same chain length.
The chain adjusters
–
Remove screws
Condition
Number of teeth: ≤ 44 teeth
–
Insert nut
–
Mount and tighten screws
Guideline
Remaining screws, chassis
Condition
Number of teeth: ≥ 45 teeth
–
Insert nut
–
Mount and tighten screws
Guideline
Remaining screws, chassis
600635-10
–
Check the rear sprocket and engine sprocket for wear.
»
If the rear sprocket and engine sprocket are worn:
–
Replace the rear sprocket or engine sprocket.
100132-10
.
.
are in the same position relative to the reference
.
are installed correctly on adjusting screws
.
can be turned through 180°.
and
. Take off the chain guide.
in hole
. Position the chain guide.
and
.
in hole
. Position the chain guide.
and
.
Info
The engine sprocket, rear sprocket and chain should always be
replaced together.
on the left and right.
5 mm (0.2 in)
so that the markings on the left
M25x1.5
90 Nm
(66.4 lbf ft)
M6
10 Nm
(7.4 lbf ft)
M6
10 Nm
(7.4 lbf ft)
64
.
Advertisement
Table of Contents
