Acura 1994 Integra Service Manual page 53

31. Remove the shift cable
I x 1 . 2 5 m m
22 f.m 12.2 kgl'rn'
16 tbl.ftl
( A / T ) .
SHIFT CABLE
32.
3 3 .
CONTROL
LEVER
SHIFT CAALE
covER
locx usiea
6 x 1 . 0 m m
14 N.m t1.4 kgf.m, 10 lbl'ftl
Replace.
Remove the damper tork.
Disconnect the suspension lower arm balljoints us-
ing the special tool. Refer to section 1 8 tor the proper
procedure.
NOTE: Adjust the tool so the iaws are parallel to
each other.
REMOVER 28 mm
oTMAC-S100200
12 x 1.25 mm
5-9
34. Remove the driveshatls.
CAUTION:
a Do not pull on tho ddv$halt, tho CV ioint mav
como apan.
a Uso caro whsn prying out tho assombly.
Pult it slraight to avoid damaging th6 differantial
oil soal or intormodiato shaft dust seal.
NOTE: Coat all precision tinished surfaces with
clean engine oil or grease. Tie plastic bags over the
driveshaft ends.
(cont'd)