Beta Enduro RR 350 2015 Workshop Manual page 97

A
120Nm
Blocking inner hub with specific tool Code
0061400400.
3
4
Juddere spring assembling.
I
Iv
Complete clutch and recommended tightening order.
8
2
1
III
II
10Nm
To unscrew the nut 8, the inner hub must be blo-
cked with a relevant tool A (code 0061400400);
the tightening torque is fixed at 120Nm after
having applied medium strength threadlocker.
Having tightened the nut, bend to two blocking
flaps on the safety plate.
Lubricate the clutch disc with gearbox oil and
apply the washer 1 in the seat on the drum, the
disc spring 2 so that the concave part faces the
washer 1, the washer 3, the special disc 4, a
driven disc and then the other discs alternating
a driving disc and a driven disc.
Insert the overall thrust bearing 9 (after ha-
ving lubricated it with gear oil) in the hole on
the main gearbox shaft and check its free axial
sliding. Close the clutch unit by means of the
clutch pressure cap 3, the four springs 13, the
fours spring retainers 14 and the four screws
15, to be tightened with a torque of 10Nm, in a
criss-cross pattern.
3
95