Beta Enduro RR 350 2015 Workshop Manual page 26

2
4
Bottom view of piston 5, elastic ring 4 and pin bolt 6.
2
Removal of gear lever.
4
Fixing screws C of ignition cover D.
24
In figure you can see the piston 5 (bottom view),
the circlip 4 and the pin bolt 6.
6
5
2.2
The ignition unit is made up of the flywheel (or ro-
tor), the pick-up and the stator which is one with
the flywheel cover.
2.2.1
Remove the screw 1 which connects the gear lever
1 to the drive shaft.
1
Remove the nine screws 3 which fasten the flywhe-
el cover 4 to the left crankcase half. Remove the
flywheel cover and the gasket placed between the
3 casing and the cover.
DISASSEMBLY of IGNItIoN
UNIt, tIMING CHAIN AND
GUIDES
STATOR AND FLYWHEEL