Beta Enduro RR 350 2015 Workshop Manual page 96

3
B
Thrust bearing device.
EXPLODED VIEW OF CLUTCH UNIT 1) Complete basket; 2) inner hub; 3) Clutch pressure cap; 4) Internal centre bearing;
5) Roller bearing 26x30x22; 6) Washer; 7) Safety washer; 8) Nut M18x1,5; 9) Overall thrust bearing; 10) Clutch body
rod coupling; 11) Thrust bearing; 12) Circlip RB14; 13) Clutch spring; 14) Clutch spring retainer; 15) Screw M6x25;
16) Steel discs; 17) Friction discs; 18) special fiction disc; 19) washer; 35) judder spring.
94
3.12.5 CHECKING THRUST BEARING
Check the state of use of the thrust bearing and
the surfaces upon which it rests. In order to check
the thrusting bearing, just see if it slides. When the
device is assembled, simulate rotation of the front
centre bearing A respect to the rear one B.
Be careful for presence traces of meshing or wear
A
on the sliding surfaces.
3.12.6 ASSEMBLY OF CLUTCH UNIT
After having lubricated the end of the main transmis-
sion shaft, insert the internal centre bearing 4 to
which the roller bearing must be coupled 5.
Insert the clutch basket 1 followed by the 21.7x38x3
washer 6, upon which the inner hub will rest 2. Put
on the safety washer 7 and after having applied me-
dium strength threadlocker, couple the lock nut 8.
In order to facilitate insertion of the clutch basket,
lightly turn the kickstart idler gear, the idler gear for
oil pump control and the basket itself, thus helping
meshing of the various gears.
DEVICE