Beta Enduro RR 350 2015 Workshop Manual page 82

3
A
Conical segment A on right side of crankshaft.
Conical segment B main gear.
Positioning Woodruff key in specific seat.
E
f
6Nm
Coupling main gear to crankshaft.
80
B
2
1
C
3
150Nm
ANTICLOCKWISE
D
3.10.2 COUPLING
PRIMARY GEARS TO THE MO-
TOR
Thoroughly degrease the conical part A on the right
side of the crankshaft and B of the primary gear.
Lubricate the segment C of the starter gear 1 with
motor oil and couple it to the crankshaft.
Insert the Woodruff key 2 in the specific seat.
Apply the main gear 3 to the crankshaft and whi-
le turning the gear clockwise, push it towards the
crankcase half until you perceive meshing between
the gear and the Woodruff key.
Insert the locking nut F applying the threading with
a medium strength threadlocker and tighten at a
torque of 150Nm.
Attention:
it must be tightened anti-clockwise.
Apply the two safety plates E bound to the casing
with screws F. Fasten at 6Nm.
IGNITION AND