Beta Enduro RR 350 2015 Workshop Manual page 33

A
Two centring pins A for cover coupling Inner clutch.
Hydraulic actuator 7 and three screws 8 coupling it to
crankcase half.
9
Extraction of clutch rod 9.
8
7
Pay attention to the two reference pins A pla-
ced between the right crankcase half and the
inner clutch cover while disassembling.
Remove the complete hydraulic actuator 7 -if
the tube was disconnect
outer left side crankcase half by loosening the
three screws 8 which fasten it to the crankcase
half. Remove the gasket in between the actua-
tor and the crankcase half.
Extract the clutch control rod 9.
2
from the actuator-
31