EXPLODED VIEW OF FLYWHEEL
18) Flywheel; 19) Elastic washer; 20) Nut M12x1;
21) Woodruff key.
8Nm
Coupling stator to flywheel cover (carburettor version).
8Nm
1
2
6Nm
Detail of flywheel cover (injection version).
60Nm
1
3
4
2
A
Degrease the conical segment of the crankshaft, ap-
ply the Woodruff key 21 in the appropriate groove
on the crankshaft, couple the flywheel 18, the elastic
washer 19 and the nut 20, after having applied the
threading with Loctite 243 / Sichel 100M medium
strength threadlocker. Tighten the nut at a torque of
60Nm.
Couple the stator to the flywheel cover by means
of screws 1. Apply the threading with medium
strength threadlocker and tighten them at a tor-
que of 8Nm.
Insert the cable gland in its specific seat and
check its perfect sealing.
Check the state of use of the two oil seals 2. If
they are deteriorated, they must be replaced.
Blow compressed air in the hole A making sure
the lubrication pipe is perfectly clean. Also
check the state of use of the chain guide 3. If
it is deteriorated, it must be replaced. In that
case, before putting on the screw 4, apply it with
medium strength threadlocker and tighten it at
a torque of 6Nm.
3
103