Beta Enduro RR 350 2015 Workshop Manual page 83

10Nm
6
Coupling electrical starter gear unit.
Insertion of start motor in crankcase half.
Note zone G to be greased.
9
The two fixing screws 9 of the start motor.
4
5
7
8
G
10Nm
Grease the two pins D and E with graphitic
grease.
Couple the idler wheel 7 to the pin D and ap-
ply the circlip 8.
Couple the torque limiter 4 to the pin E tur-
ning the gearwheel with the smaller diameter
towards the crankcase half. Insert the washer
5 and the screw 6 after having spread the th-
reading with medium strength threadlocker.
Tighten the screw at a torque of 10Nm.
Apply a light layer of grease in the area G of
the start motor and insert the motor in its
housing.
Apply medium strength threadlocker on the
two screws 9 and tighten them with a torque
of 10Nm.
3
81