Beta Enduro RR 350 2015 Workshop Manual page 49

Two screws A blocking engine to engine support
stand.
Disassembly of crankcase.
Detaching crankcase halves.
5
The left crankcase half (inside) with references pins
4 and 5.
A
2
3
4
Loosen the two screws A which fasten the engi-
ne to the support stand.
Hit the left crankcase half 2 lightly with a rub-
ber or plastic hammer until it detaches from
the right crankcase half 3. Remove the two
screws blocking the engine to the equipment
and disassemble the crankcase by hand.
ATTENTION: The gearbox unit and the
crankshaft must remain inside the right
crankcase half.
Remove the back 4 and front reference bushes
5 to position the crankcase correctly. Remove
the gasket between the two crankcase halves.
2
47