Beta Enduro RR 350 2015 Workshop Manual page 79

EXPLODED VIEW OF COMPLETE KICKSTART SHAFT
2) Kickstart gear;
3) Kickstart shaft;
8) Kickstart return spring;
9) Kickstart spacer;
10) Circlip 20E;
11) 20x28x1 washer DIN 988;
12) Roller bearing K20x24x10;
14) Kickstart sleeve;
16) Spring
Positioning of sleeve on small shaft.
Widen the circlip 10, thus slipping off the wa-
sher 11, and the kickstart gear 2 as well the
roller bearing 12 and the washer 11. This frees
the kickstart shaft 3 from all other elements.
Make sure that the side of the kickstart gear
teeth 2 have no signs of meshing or superficial
wear. Make sure that the front teeth (sleeve
side 14) are not chipped. Replace any element
that has the aforementioned defects.
Make sure that the front teeth of the sleeve 14
are not chipped and that the spring 16 is capa-
ble of putting enough pressure on the sleeve
14
14 so that it can to pull the gear 2.
Also check to make sure that the washers have
no abnormal or excessive wear. If so, have
them replaced. Make sure that the spring 8
has no cracks or abnormal deformation. Have
it replaced if it is not able to bring the external
kickstart lever back to the rest position.
For reassembly, proceed inversely compared
to the previously-described disassembly pro-
cedures.
Pay attention to the correct positioning of the
sleeve 14 respect to the shaft 3. The front of
the shaft has a reference sign, just as the slee-
ve does14: the two references must match.
3
3
77