3
10Nm
Coolant pump cover: pay attention to washer 3.
4 screws that fasten the outer clutch cover to the
inner cover.
100
3
4
Couple the water pump cover to the inner clutch
cover applying the four M6x40 screws, making sure
to apply the copper washer 3 to the lower screw of
the pump cover.
Tighten all thirteen screws at a torque of 10Nm fol-
lowing a criss-cross pattern.
If only the outer clutch cover was removed, put it
back on the inner cover and fasten the six M6x25
screws as shown in the figure.