Beta Enduro RR 350 2015 Workshop Manual page 121

A
3
Insertion of shaft 1 on outermost finger follower 2.
Application of two finger follower shaft caps.
2
1
10Nm
4
17Nm
B
3.17.10 CYLINDER HEAD: REPO-
SITIONING
DISCS, ASSEMBLY OF FIN-
GER FOLLOWER SHAFTS
AND FINGER FOLLOWERS
AND COUPLING
SPARK PLUG
Clamp the cylinder head using protective jaws,
gripping it at the head connection A.
Put the calibrated discs 1 back in place in
their original positions (if not deteriorated see
par.1.17.3.3).
Insert the finger follower shaft 2 partly in the spe-
cific seat as much as needed to be able to insert
the outermost finger follower into the cylinder
head first 3. Having fastened the outermost fin-
ger follower to the shaft, push the shaft further
until it reaches the seat of the innermost finger
follower. Having coupled the innermost finger
follower to the shaft push it all the way into the
cylinder head.
Couple the two caps 4 with the O-rings to the
cylinder head. They must be tightened at a tor-
que of 10Nm.
Apply the spark plug on the special wrench B
(code 020440100 000), introduce the unit in
the specific housing and tighten at a torque
of 17Nm.
3
CALIBRATED
THE
119