Beta Enduro RR 350 2015 Workshop Manual page 72

3
Application of forks to gearwheels.
7
Insertion of desmodromic device in specific bearing.
Note the rotation of the stop lever.
5
Positioning of primary unit fork 5 in central guide of
desmodromic device 8.
70
5
6
6
Introduce the forks together with the drive bushes
on the gear tracks. To be precise; the smaller fork
5 drives the sliding gear on the primary unit, while
the other two (6) drive the sliding gears on the se-
condary unit.
Note: the two forks 6 are interchangeable and their
positioning is univocal, since the drive pin must face
the desmodromic device. If none of the components
in question is replaced, it is recommended to repo-
sition the forks in their original positions.
Insert the desmodromic device in the specific bea-
ring. In order to do this, it is necessary to rotate cam
stop lever 7 towards the bottom part of the engine.
Position the fork 5 of the primary unit in the central
guide of the desmodromic device 8, insert the fork
pin inside the fork itself and insert the pin in its
proper seat in the crankcase half.
8