Beta Enduro RR 350 2015 Workshop Manual page 81

1
Idler wheel 1.
2
Torque limiter 2.
5
4
Free wheel coupled to main gear.
3
Main gear complete with free wheel coupled to
ignition gear.
A
5
3.10 ELECtRICAL
UNIt AND MAIN GEAR
Carry out the following controls before assem-
bly.
3.10.1 CHECKING
STARTER
MENTS
Make sure that the teeth of all the gearwheels
of the device are intact, free from chipping or
signs or abnormal wear.
Pay attention to the teeth of the idler wheels
1 and torque limiter 2 and between the gears
and respective support pins. Replace them if
they show signs of meshing or seizure.
Make sure there are no traces of meshing on
the housing of the roller bearing on the starter
gear 3. Mount the starter gear temporarily on
the crankshaft, together with the roller bearing
and check to see if there is excessive play.
To check the correct functioning of the free
wheel 4 proceed as follows.
Insert the starter gear 3 on the free whe-
el 4 and main gear unit 5. Keeping the main
gear blocked 5 and turning the kickstart gear
3 clockwise, it must run freely. Turning the
kickstart gear 3 anti-clockwise, it must be blo-
cked without idling.
To replace the free wheel, disassemble the
special circlip A and remove the free wheel.
During disassembly make sure that the lugs on
the outer edge of the special circlip A are cou-
pled in the slots of the free wheel and in the
groove inside the main gear.
StARtER
ELECTRICAL
DEVICE ELE-
3
79