2
Remove the crankshaft blocking screw 6,
remove the copper washer 7 and put the
screw (or tool 006140110 000) back into its
seat without tightening it all the way.
7
6
After having engaged the 6th gear, turn the
transmission shaft 8 anti-clockwise - using
an open-end spanner or the likes, - until
the lines 9 on the toothed profiles of the
camshafts are aligned.
8
9
Rotate the transmission shaft in that posi-
tion and, at the same time, turn the shaft
blocking screw 6 by hand until it engages in
the seat present on the crankshaft, preven-
ting the crankshaft from turning.
In this way the crankshaft is blocked, by me-
6
ans of the screw 6, at the Top Dead Centre
(TDC) and now all the organs can be disas-
sembled.
17