3
B
Positioning of sleeve A below ramp B.
Insertion of kickstart return spring.
Engine side
Kickstart device unit coupled to the crankcase.
78
3.9.2
Insert the complete kickstart shaft in its housing
keeping the thin-striped facing outwards and ma-
king sure that the ramp A on the kickstart sleeve is
A
positioned below the ramp B bolted onto the right
crankcase (external side).
Turn the spring clockwise until it fits into the spe-
cific hole C.
C
Insert in the slot on the protruding segment of the
secondary shaft: the circlip 18, the washer 17, the
idler wheel 4 followed by the washer 17 and the
circlip 18 as shown in the figure.
ASSEMBLY OF KICKSTART DE-
VICE