Beta Enduro RR 350 2015 Workshop Manual page 70

3
Make sure the distance A between the outer faces of
the fork is not less than that indicated below:
A
Minimum acceptable distance: 4.25mm
Check to make sure that the inside diameter D of the
fork pin seats is below the limit:
Fork inside diameter limit: 13,83mm
Make sure that the fork pins upon which they slide
have an outside diameter above the limit (to be
measured in the sliding areas of the forks and in
the housing areas of the crankcases):
Fork pin outside diameter limit: 13,75mm
Make sure that the desmodromic control device has
no corroded or worn areas especially in the grooves
in which the drive pins of the forks are engaged.
Di
Pin
68