Beta Enduro RR 350 2015 Workshop Manual page 58

3
EXPLODED VIEW OF STOPPING DEVICE
25) Lever;
26) Spring;
27) Spacer;
28) Washer 6x20x1;
29) Screw M6x20.
10Nm
Stopping device coupled with the crankcase half.
56
The crankcase half will definitely need to be repla-
B
ced when:
•
•
A
Keeping the tightener on the lever 25 facing to-
wards the crankcase half, apply the spacer 27 onto
it, by inserting the smaller diameter segment in the
lever. Apply the spring 26 so that the hook inserts
into the groove present on the lever 25 and then
apply the washer 28 and the screw 29 M6x20 who-
se threading must be spread with medium strength
threadlocker.
Apply the entire device on the crankcase half so
that the straight segment of the spring rests on the
stop C. Tighten the screw at 10Nm.
C
the oil pump crankcase A shows deep scratches
or meshing signs;
the two pins B for the idler wheel and torque li-
miter show traces of abnormal wear or meshing.