Resetting Defaults; Resetting Power-On Defaults; Resetting Factory Defaults; Resetting Factory Defaults In Menu1 And Menu2 - Fujitsu DL7600 User Manual

RESETTING
DEFAULTS
User's Manual
This section describes how to reset the printer's power-on defaults, all of
the factory defaults, or the factory defaults only for MENU1 and
MENU2.

Resetting Power-On Defaults

Power-on defaults are the settings saved in the printer's permanent
memory. The defaults are enabled whenever you turn the printer on.
The only (LED type) way to reset the power-on defaults is to turn the
printer off and then on again. This method is useful if you have made
changes in setup mode that you do not want to save. LCD type, save or
cancel options are available on exit menu.

Resetting Factory Defaults

Factory defaults are those settings preselected at the factory. For a list of
the printer's factory defaults, see the section Printing a List of Selected
Options earlier in this chapter. To reset the factory defaults for all
functions, proceed as follows:
1. Turn off the printer.
2. While pressing the LOAD and, TEAR OFF buttons, turn on the
printer. Continue to press the two buttons until the printer beeps.
The factory defaults are now reset.
Another available method is to select INITIAL in SETUP mode.
The method of making settings is the same as the method for
selecting DEFAULT on the next page, except that INITIAL
must be selected instead of DEFAULT.
Resetting Factory Defaults in MENU1 and
MENU2
This method resets factory defaults for MENU1 and MENU2 options,
listed in Table 5.4, but does not reset the printer hardware, print position
adjustment, and configuration options.

Procedure (for LED type)

To reset the factory defaults in MENU1 and MENU2, select DEFAULT
in SETUP mode. Detail of method as follows:
1. Enter setup mode (LED type).
Press the AUTO GAP button and the HI IMPACT button
simultaneously until the printer beeps. Wait for the printer to
stop printing and check that the following <<FUNCTION>>
menu is printed:
USING SETUP MODE
5-53