Buell XB 2008 Series Service Manual page 49

provide 1/16-1/8 in. (1.6-3.2 mm) free play at clutch hand
lever. Adjust as follows:
a. See Figure 1-29. Pull ferrule (end of cable housing)
away from bracket. Gap between ferrule and bracket
should be 1/16-1/8 in. (1.6-3.2 mm).
b. See Figure 1-27. Set free play by turning adjuster (4).
c. Tighten jam nut (3) against adjuster (4).
d. Slide boot (1) over cable adjuster mechanism.
7. Change or add transmission fluid if necessary.
NOTE
Each time the clutch inspection cover is removed, the gasket
must be replaced.
8. See Figure 1-25. Install clutch inspection cover and new
gasket using three fasteners and washers and tighten to
84-108 in-lbs (10-12 Nm).
sm00090
1
2
3
4
1. Rubber boot
2. Cable end
3. Jam nut
4. Adjuster
Figure 1-27. Clutch Cable Adjuster Mechanism
sm00091
2
1
1. Diaphragm spring
2. Lockplate
3. Adjusting screw
Figure 1-28. Clutch Adjustment: XB Models
om01020
3
1
1. Ferrule
2. Bracket
3. 1/16-1/8 in. (1.6-3.2 mm)
Figure 1-29. Clutch Cable Free Play
2008 XB Service: Maintenance 1-27
3
2