Installation - Buell XB 2008 Series Service Manual

sm00376
1
2
3
1. Air cleaner cover
2. Fuel tank vent assembly
3. Fuel tank vent tube
4. Actuator, interactive exhaust
5. Cable, interactive exhaust
6. Harness, interactive exhaust
Figure 7-57. Air Cleaner Cover (XB12 Models)

INSTALLATION

NOTES
Never reuse front muffler strap. Always replace front
muffler strap with a new strap when removed from system.
It is necessary to install interactive exhaust cable to muffler
with muffler only partially installed.
1. Install muffler. See 4.16 EXHAUST
2. Install interactive cable onto vehicle.
a. Slip end of hose over upper end of cable and attach
with tape.
b. See Figure 7-58. Gently pull cable assembly up
through the wire harness strap and guide at the left
rear corner of the frame/fuel tank assembly. See
1.15 INTERACTIVE EXHAUST
3. Install actuator. Tighten fasteners to 36-40 in-lbs (4.1-4.5
Nm).
4. Attach interactive exhaust cable to cable wheel on actu-
ator.
5. Connect interactive exhaust harness to actuator [161B].
6. Attach interactive exhaust cable to bracket and cable
wheel on actuator and adjust. See
EXHAUST CABLE.
7-42 2008 XB Service: Electrical
7.
8.
4
9.
5
10. Install chin fairing. See
11. Install intake cover. See
6
12. Install negative battery cable to battery terminal. Tighten
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
13. Install seat.
SYSTEM.
CABLE.
1.15 INTERACTIVE
Install cable strap above starter securing actuator cable,
vent line, main harness and positive battery cable.
Install cable strap securing actuator cable, neutral switch
and oil pressure wiring.
Install front sprocket cover. See
2.53 CHIN
2.40 INTAKE
fastener to 72-96 in-lbs (8-11 Nm).
sm00377
Figure 7-58. Interactive Exhaust Cable Behind Wire
Harness Strap and Guide
2.38 SPROCKET COVER.
FAIRING.
COVER.