Front Turn Signals; Bulbs - Buell XB 2008 Series Service Manual

FRONT TURN SIGNALS

BULBS

Repair
1. Remove screw on back of housing to access turn signal
bulbs.
2. Rotate bulb a 1/4 turn and remove.
3. Before replacing, apply a light coat of dielectric grease on
the bulb contact terminals.
4. Install screw and tighten to 4.4-4.3 in-lbs (0.5-0.6 Nm)
Connections and Wire Routing
To ensure correct installation, make note of wire routing and
cable strap locations before removing turn signals.
sm00402
1
2
1. Left turn signal
2. Right turn signal
Figure 7-45. Front Turn Signal Connections
FIREBOLT
Removal
1. Disconnect bullet connectors on turn signal wires.
2. See Figure 7-46. Remove fastener (3) and lockwasher (2)
from fairing support bracket (4).
3. Pull bullet connectors and wiring through hole in fairing
support bracket (4) and fairing (5).
Installation
1. See Figure 7-46. Insert bullet connectors and wiring
through hole in fairing (5) and fairing support bracket (4).
2. Install turn signal (1) using lockwasher (2) and fastener
(3). Tighten fastener to 25-28 in-lbs (2.8-3.2 Nm).
3. Attach bullet connectors on turn signal wires as shown in
Figure 7-45.
7-32 2008 XB Service: Electrical
1 1 V
BE
BK 2 2 BK
[31B]
[31A]
BK
BK 2 2
BE 1 1 BN
[31B]
[31A]
4. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were performed.
a. Turn ignition/key switch to ON.
b. Activate left turn signals using switch on left
handlebar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left
handlebar. Front and rear right turn signals must flash.
d. Turn ignition/key switch to OFF.
sm00403
3
2
1
1. Turn signal (2)
2. Lockwasher (2)
3. Fastener (2)
4. Fairing support bracket
5. Fairing
6. Bulb
Figure 7-46. Front Turn Signals: Firebolt
LIGHTNING
Removal
1. Remove windscreen. See
WINDSCREEN: LIGHTNING AND
2. Disconnect bullet connectors on turn signal wires.
3. See Figure 7-47. Remove jam nut and lockwasher (2) from
inside of front module (3).
4. Pull bullet connectors and wiring through hole in front
module (3) and remove turn signal (1).
Installation
1. See Figure 7-47. Insert bullet connectors and wiring
through hole in front module.
7.12
4
5
6
2.50 WINDSHIELD AND
ULYSSES.