Installation - Buell XB 2008 Series Service Manual

sm03877
3
1. Upper module
2. Left module
3. Right module
Figure 2-150. Front Modules: Ulysses

INSTALLATION

1. Install right front module leaving single fastener loose.
2. After installing the left front module and aligning with holes
in upper triple clamp, tighten previously installed single
fastener to 12-14 ft-lbs (16.3-19 Nm).
2-102 2008 XB Service: Chassis
3. Attach front brake line p-clamp to rear of right front module
and tighten fastener to 36-60 in-lbs (4.1-6.8 Nm).
4. Install ignition switch. See
1
SWITCH.
5. Install
7.22 INSTRUMENT
6. Connect turn signals. See
2
7. See
module. Tighten fasteners to 36-60 in-lbs (4.1-6.8 Nm).
8. Connect speedometer.
9. On Ulysses model, connect auxiliary outlet.
10. Install headlamp assembly and support bracket. See
2.28 HEADLAMP ASSEMBLY AND SUPPORT
11. Install windshield and windscreen. See
AND WINDSCREEN: LIGHTNING AND
Connect positive (+) battery cable first. If positive (+) cable
should contact ground with negative (-) cable connected,
the resulting sparks can cause a battery explosion, which
could result in death or serious injury. (00068a)
12. Connect battery cables to battery: positive cable (red) first.
Tighten to 72-96 in-lbs (8-11 Nm). See
MAINTENANCE.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
13. Install seat.
7.3 IGNITION/HEADLAMP KEY
and connect instrument
MODULE.
7.12 FRONT TURN
Figure 2-150. On Ulysses models, install upper
module. See
SIGNALS.
BRACKET.
2.50 WINDSHIELD
ULYSSES.
1.4 BATTERY