Installing Pin Terminal - Buell XB 2008 Series Service Manual

2. See Figure A-2.
a. Fit the barrel of the PIN TERMINAL REMOVER (Part
No. HD-39621-28) over the pin, and while rotating
the tool slightly, push until it bottoms in the housing.
Allow the plunger to "back out" of the handle.
b. Holding the pin housing while keeping the tool firmly
bottomed, depress the plunger. The terminal pops
out the wire end of the connector.
NOTE
If the terminal is not released from the pin housing, then the
terminal was not pushed forward far enough before placement
of the tool or the tool was not bottomed in the connector
housing.

Installing Pin Terminal

1. Push the lead into the pin housing until it stops. A click is
heard when the terminal is properly seated.
2. Gently tug on the lead to verify that the terminal is locked
in place.
A-2 2008 XB Service: Appendix A Connector Repair
sm00012
2
1
3
6
1. Pin housing
2. Barrel
3. Barrel bottomed in connector
4. Plunger backed out of the handle
5. Depressed plunger
6. Pin terminal
Figure A-2. AMP Pin Terminal Remover (HD-39621-28)
4
5