Buell XB 2008 Series Service Manual page 643

sm03608
1. Solenoid shaft
2. Cable adjusting and jam nuts
3. Solenoid bracket
4. Cable housing
Figure E-2. Checking for Freeplay in the Solenoid Shaft in the Fully Extended Position
Throttle Stop Screw
1. Remove cosmetic intake cover assembly and functional
air cleaner cover. See 2.40 INTAKE COVER
CLEANER AND EXHAUST
2. Hold throttle to wide open position and use cable strap to
free hands.
NOTE
It is necessary to pull velocity stack out of the way to access
set screw.
3. Activate Active Intake System using DIGITAL TECHNI-
CIAN.
and 1.13 AIR
SYSTEM.
2008 XB Service: Appendix E Active Intake (Japanese Models) E-3
2
1
3
4. Adjust stop screw, while reading the TPS on Digital
Technician, until setting is between the range of 10.4 to
10.9.
a. If the reading is below 10.4, adjust screw clockwise.
b. If the reading is above 10.9, adjust screw counterclock-
wise.
5. Confirm the TPS setting. Repeat process if needed.
6. Adjust active intake cable assembly. See
INTAKE SYSTEM (JAPANESE MODELS ONLY),
7. Verify active intake TPS settings.
8. Install cosmetic intake cover assembly and functional air
cleaner cover. See
CLEANER AND EXHAUST
4
E.1 ACTIVE
2.40 INTAKE COVER and
SYSTEM.
Cable.
1.13 AIR