Buell XB 2008 Series Service Manual page 112

4. Remove cotter pin from brake pedal. See
PEDAL.
5. Remove seat.
6. See Figure 2-54. Disconnect brake light connector located
under the seat.
sm00488
Figure 2-52. Rear Caliper Bleeder Valve
sm00549
4
2
1. Reservoir hose
2. Cotter pin
3. Banjo bolt (metric)
4. Fasteners (2)
Figure 2-53. Rear Master Cylinder: Ulysses
7. See Figure 2-56. Remove rear brake light switch (1)
(metric) and two copper crush washers (3) to detach brake
line (2) from master cylinder (4). Discard copper crush
washers.
2-36 2008 XB Service: Chassis
2.11 BRAKE 8. Remove fasteners (11) to detach master cylinder (4) from
rider footpeg mount.
9. See Figure
a. On Ulysses models, remove air flow guide.
b. Remove top clamp (2) on hose connected to master
cylinder.
c. Remove fastener and washer (3) to detach reservoir
(1) from frame if necessary.
sm00546
Figure 2-54. Brake Line Switch Connector (Ulysses)
sm00547
3
2
1
3
1. Reservoir
2. Clamp
3. Fastener and washer
4. Remote reservoir hose
Figure 2-55. Remote Reservoir: Ulysses
2-55. Detach remote reservoir.
1
4