Removal: Ulysses Models; Installation: Ulysses Models - Buell XB 2008 Series Service Manual

sm00689
7
8
9
10
11
1. Seat lock
2. Plate
3. Retainer
4. Cable end
5. Cable
6. Latch screw

REMOVAL: ULYSSES MODELS

1. Remove seat.
2. Cut cable strap securing wire harness to seat lock cable.
3. See Figure 2-204. Disconnect seat lock cable (5):
a. Remove latch (8) from latch bracket (9) by removing
two fasteners (7).
b. Remove cable end (6) and cable (5) from latch (8).
4. Remove seat lock:
a. Remove wire cover from bottom side of license plate
bracket to access seat lock.
b. Remove seat lock retainer (3) from seat lock (1).
c. Remove seat lock (1) from plate (2) and license plate
bracket.
2-150 2008 XB Service: Chassis
6
Figure 2-203. Seat Lock Assembly: Lightning
When removing seat lock (1), cable end (4) should release
from seat lock.
5.

INSTALLATION: ULYSSES MODELS

1.
2.
5
4
3
7. Retainer
8. Cable end
9. Latch
10. Latch bracket
11. Trunk pan
NOTE
Remove cable (5) from plate (2).
See Figure 2-204. Install cable (5) into plate (2).
Install the seat lock (1) into license plate bracket and plate
(2).
NOTES
Once seat lock has been started through the hole in the
license plate bracket and plate (2), now is the time to
connect the cable end to the seat lock.
Seat lock plate must be aligned to tab on seat lock for
proper installation.
1
2