Buell XB 2008 Series Service Manual page 671

2008 Buell XB Models Service Manual
FASTENER
Oil line p-clamp fastener
Oil line p-clamp fastener
Oil line p-clamps at swingarm
Oil pressure signal light switch
Oil pump body and cover fasteners
Oil pump body and cover fasteners
Oil pump body and cover fasteners
Oil pump body and cover fasteners
Oxygen sensor
Passenger grab handle, front fasteners
Passenger grab handle, rear fasteners
Passenger seat latch, Firebolt
P clamp, front tie bar and clutch cable
Pinch fastener
Pinch fastener
Pinion shaft nut
Piston jet assembly screws
Preload adjuster knob fastener
Preload adjuster mounting
Preload adjuster to trunk pan
Primary chaincase drain plug
Primary chain inspection cover fasteners
Primary chain tension locknut
Primary cover fasteners
Primary drain plug
Primary magnetic drain plug
Pushrod adjustment locknut
Pushrod cover screws
Pushrod cover screws
Ram air scoop fasteners
Rear axle (final torque)
TORQUE VALUE
48-72 in-lbs 5.4-8 Nm
48-72 in-lbs 5.4-8 Nm
48-72 in-lbs 5.4-8 Nm
96-120 in-lbs 10.8-13.6 Nm
100-120 in-lbs 11.3-13.6 Nm
108-156 in-lbs 12.2-17.6 Nm
96-120 in-lbs 11-13.8 Nm
72-96 in-lbs 8-11 Nm
40-45 ft-lbs 54-61 Nm
96-120 in-lbs 11-13.5 Nm
23-25 ft-lbs 31-34 Nm
60-96 in-lbs 7-11 Nm
25-27 ft-lbs 33.9-36.6 Nm
48-60 in-lbs 5.4-6.7 Nm
48-60 in-lbs 5.4-6.7 Nm
19-21 ft-lbs 26-29 Nm
25-35 in-lbs 2.8-4.0 Nm
25-43 in-lbs 2.8-4.9 Nm
36-60 in-lbs 4.0-6.7 Nm
36-60 in-lbs 4-6.7 Nm
14-30 ft-lbs 19-40.7 Nm
84-108 in-lbs 10-12 Nm
20-25 ft-lbs 27-34 Nm
100-120 in-lbs 11.3-13.5 Nm
14-30 ft-lbs 19-41 Nm
14-30 ft-lbs 19-40.7 Nm
130-173.5 in-lbs 14.7-19.6 Nm
30-40 in-lbs 3.4-4.5 Nm
30-40 in-lbs 3-5 Nm
12-36 in-lbs 1-4 Nm
48-52 ft-lbs 65.1-70.5 Nm
NOTES
3.5 ENGINE INSTALLATION, Assembly
3.5 ENGINE INSTALLATION, Assembly
2.21 SWINGARM AND BRACE, Installation:
Swingarm
3.13 OIL PRESSURE INDICATOR SWITCH, Oil
Pressure / LOCTITE 565 HIGH PERFORMANCE
PIPE SEALANT WITH TEFLON
3.9 OIL PUMP, Assembly/Installation
3.9 OIL PUMP, Assembly/Installation
3.9 OIL PUMP, Assembly/Installation
3.9 OIL PUMP, Assembly/Installation
4.6 OXYGEN SENSOR, Installation / ANTI-SEIZE
2.56 TRIPLE TAIL: ULYSSES, Installation
2.56 TRIPLE TAIL: ULYSSES, Installation /
LOCTITE 271 (red)
2.41 SUBFRAME TAIL ASSEMBLY AND BODY
WORK: FIREBOLT, Assembly
2.27 CLUTCH CONTROL, Assembly and Installa-
tion
E.1 ACTIVE INTAKE SYSTEM (JAPANESE
MODELS ONLY), Installation
E.1 ACTIVE INTAKE SYSTEM (JAPANESE
MODELS ONLY), Installation
3.16 GEARCASE AND CAM GEARS, Assembly
and Installation / Plus an additional 15° to 19°
rotation
3.17 CRANKCASE, Piston Jets / TORX, LOCTITE
LOW STRENGTH THREADLOCKER 222 (purple)
2.25 REAR SHOCK ABSORBER, Removal:
Ulysses
2.25 REAR SHOCK ABSORBER, Installation:
Ulysses
2.45 LEFT TAIL SECTION AND BATTERY PAN:
XB12X/XB12XT, Assembly
1.3 MAINTENANCE SCHEDULE, General
1.10 PRIMARY CHAIN, Inspection
1.10 PRIMARY CHAIN, Adjustment
6.2 PRIMARY COVER, Installation
1.8 CLUTCH/TRANSMISSION/PRIMARY
FLUID, Transmission Fluid
6.2 PRIMARY COVER, Installation / LOCTITE 565
1.6 BRAKE SYSTEM MAINTENANCE, Brake Pedal
Adjustment
3.6 CYLINDER HEAD, Push Rod Cover Installation
3.15 HYDRAULIC LIFTERS, Installation
2.52 AIR SCOOPS, Ram Air Scoop
2.21 SWINGARM AND BRACE, Brace
TORQUE VALUES XIX