Disassembly: Ulysses - Buell XB 2008 Series Service Manual

sm00475
1. Turn signal flasher connector [30]
2. Instrument cluster connector [39]
3. Right handlebar connector [22]
4. Left handlebar connector [24]
5. Turn signal connectors [31]
6. Ignition switch

DISASSEMBLY: ULYSSES

1. See Figure 7-13. Remove housing (4) from ignition switch
(5) by prying tabs on side of housing.
2. Remove body fasteners (1). Separate body (2) from
ignition switch (5).
ASSEMBLY: ULYSSES
NOTE
See Figure 7-13. In next step, be sure wide slot in housing (4)
is installed over wide boss on ignition switch (5).
1. Push housing (4) on to ignition switch (5).
3
5
Figure 7-12. Electrical Connectors Behind Windscreen: Ulysses
2
5
6
9
11
7
8
12
7. Cable strap
8. Main harness
9. Horn fastener
10. Horn mount
11. Horn connector [122]
12. Horn
In next step, do not force ignition switch (5) into body (2). If
ignition switch does not easily slide into ignition switch body,
rotate slot in ignition switch body with screwdriver until proper
installation can be achieved.
2. Mate ignition switch (5) to body (2).
3. Install body fasteners (1). Tighten to 12-36 in-lbs (1.4-4.0
Nm).
4
1
5
10
NOTE
2008 XB Service: Electrical 7-13