Deflectors: Xb9Sx/Xb12Stt/Xb12X/Xb12Xt; Removal And Disassembly - Buell XB 2008 Series Service Manual

DEFLECTORS: XB9SX/XB12STT/XB12X/XB12XT

REMOVAL AND DISASSEMBLY

1. Figure 2-146. Remove fasteners (2) from clutch and brake
pivot shafts (3, 6) and pivot shaft risers (4).
2. Unsnap deflectors (1) from handlebar end caps (7).
3. Lift deflectors off of the pivot shafts (3, 6) and pivot shaft
risers (4).
4. Loosen pivot shaft riser (4) and jam nut (5) and remove
from both pivot shafts (3, 6).
5. Remove pivot shafts (3, 6) with levers.
sm00599
7
1
1. Deflectors
2. Deflector fasteners (4)
3. Clutch pivot shaft
4. Pivot shaft riser
Figure 2-146. Deflectors: XB9SX, XB12STT, XB12X and XB12XT Models
ASSEMBLY AND INSTALLATION
1. Install brake and clutch levers with pivot shafts (3, 6). See
2.27 CLUTCH CONTROL
MASTER CYLINDER AND HAND
2. Install jam nuts (5) and tighten to 39-48 in-lbs (4.4-5.4
Nm).
3. Install pivot shaft risers (4) and tighten to 43-49 in-lbs (4.8-
5.5 Nm).
4. Spread deflectors (1) and place over the pivot shaft and
riser ends.
5. Snap deflectors onto handlebar end caps (7).
6. Install new deflector fasteners (2) and tighten to 24-36 in-
lbs (2.7-4.1 Nm).
2
6
5
4
2
5. Pivot shaft jam nut
6. Brake pivot shaft
7. Handlebar end caps
and
7
2
3
2
5
4
2008 XB Service: Chassis 2-99
2.30
2.8 FRONT BRAKE
LEVER.
1