Disassembly: Lightning - Buell XB 2008 Series Service Manual

sm00476
4
1. Socket head fastener (1) with spacer behind switch
2. Tamper-resistant Torx fasteners (2)
3. Throttle cables
4. Ignition switch as positioned on vehicle
5. Fork stop pin (retracted)

DISASSEMBLY: LIGHTNING

1. See Figure 7-9. Remove ignition switch housing (5) from
ignition switch (4) by prying tabs on side of housing.
2. Remove ignition switch body fasteners (1). Separate
ignition switch body (2) from ignition switch (4).
ASSEMBLY: LIGHTNING
NOTE
See Figure 7-9. In next step, be sure wide slot in ignition switch
housing (5) is installed over wide boss on ignition switch (4).
3
Figure 7-8. Ignition Switch: Lightning (Typical)
1
2
1. Push ignition switch housing (4) on to ignition switch (5).
In next step, do not force ignition switch (5) into ignition switch
body (2). If ignition switch does not easily slide into ignition
switch body, rotate slot in ignition switch body with screwdriver
until proper installation can be achieved.
2. Mate ignition switch to ignition switch body.
3. Install ignition switch body fasteners (1). Tighten to 12-36
in-lbs (1.4-4.0 Nm).
5
NOTE
2008 XB Service: Electrical 7-9