Installation: Lightning/Ulysses - Buell XB 2008 Series Service Manual

2. Place rear shock reservoir assembly (3) into position.
NOTE
See Figure 4-51. To ensure proper reservoir mounting, tempor-
arily place upper body work onto tail section and adjust reser-
voir placement so adjuster screw (1) aligns with alignment hole
(2).
3. See Figure 4-50. Install reservoir mounting fasteners (2).
Tighten fasteners to 120-144 in-lbs (13.6-16.3 Nm).
NOTES
Always make sure fuel hoses are seated against the
component they connect to and that hose clamps are
properly tightened and positioned on straight section of
fitting and not on the fitting barb.
The barb is the larger outside diameter portion (bump) on
the fuel fitting.
4. See Figure 4-50. Connect two hoses to the canister. Make
sure to push hoses all the way on to carbon canister fit-
tings.
5. Install upper tail body work. See
ASSEMBLY AND BODY WORK:
sm00904
1
1. Mounting plate
2. Rear shock reservoir fasteners (2)
3. Rear shock reservoir
4. Battery
Figure 4-50. Carbon Canister Mounting
2.41 SUBFRAME TAIL
FIREBOLT.
2
3
4
sm00905
2
1
1. Adjuster screw
2. Adjuster screw alignment hole
Figure 4-51. Adjuster Screw Alignment

INSTALLATION: LIGHTNING/ULYSSES

Vent Valve
Keep vent and vapor valve lines away from exhaust and
engine. Gasoline is extremely flammable and highly
explosive, which could result in death or serious injury.
(00263a)
NOTE
For XB12 models, See
SYSTEM.
1. Install vent valve. See 4.11 FUEL TANK VENT
2. See Figure 4-50. Attach fuel tank vent hose (2) to canister
if disconnected.
Canister
NOTE
In next step, be sure canister hose barbs are facing rear of
vehicle at approximately the 1 o'clock position.
1. See Figure 4-54. Slide canister into position on canister
mounting plate and push towards front of vehicle.
NOTES
Always make sure fuel hoses are seated against the
component they connect to and that hose clamps are
properly tightened and positioned on straight section of
fitting and not on the fitting barb.
The barb is the larger outside diameter portion (bump) on
the fuel fitting.
2. See Figure 4-50. Connect two hoses to the canister. Make
sure to push hoses all the way on to carbon canister fit-
tings.
2008 XB Service: Fuel System 4-39
7.14 INTERACTIVE EXHAUST
VALVE.