Installing; Driven Pu Ll Ey; Removing - Arctic Cat 1987 AFS El Tigre Service Manual

INSTALLING
1. Place t he c lu tch into posit ion on the
crankshaft.
2. Install the pilot washer, lock washer, and bolt.
Tighten the bolt to 6.9 kg-m (50 ft-Ib) max-
imum.
8413
3. Check a lignm ent betwee n the drive clutch
and driven pulley.
4. Install plug in the belly pan.
5. Instal l the drive be lt and secure the c lutch
shield.
(~
____ D __ ri_v_e_n __ p_U_I_le_Y _____
J
REMOVING
1. Open the clutch shield .
2. Remove the drive belt.
3. Remove the cap- lock screw and washer; then
account for and note the position of any al ign-
ment washers.
78
Fig. 4·71
4. Slide the driven pulley off the driven shaft;
then remove pulley from the engine compart-
ment. Remove the stub shaft from the driven
pulley.
Fig. 4·72
5. Remove the key and alignment washers from
the driven shaft.